Low pressure pipelines are often made out of HDPE pipe. These low pressure lines are suited to handle low pressure gas such as gas produced from shallow wells or coal bed methane applications where a lot of water and/or condensate is produced.
Economics often dictate liquids are not removed at the production site or wet metering is done and liquids remain in the line. Operational problems related to accumulations in low spots may result.
This in turn may cause back pressure on wells, reducing gas flow in the pipeline.
The standard approach for the removal of these unwanted liquids is large equipment like conventional gas/liquid separators or filters and coalescers. These applications are costly, less effective and more expensive to maintain than Innopipe separators.
Innopipe can help you address a wide variety of pipeline concerns. If you have a 2 phase gas/liquid problem requiring a negligible delta P, quick delivery, low cost, highly effective piggable or non-piggable solution, Innopipe can help for the following situations:
- Metering accuracy improvement
- Compressor protection/lube removal
- Tower carry-overs
- Pre-river crossing dewatering
- Corrosion prevention
- Black powder removal
- 1”-60″ lines
- Low points in pipelines
- Slug management
Also ask about our 3-phase separation capabilities. The upper Innopipe separator handles 90+% of the gas stream, whereas the lower vessel handles mostly liquid volumes, allowing for a much smaller combination of vessels than traditional separation equipment. Smaller vessels means lower capital cost and faster delivery.
We have an almost 3 decade track record at ANY pressure/temperature range you need. Call us at +1 403 215-3373, [email protected], or visit www.Innopipe.com