Any blanks you can fill in below will expedite your quote, as well as reduce your change-order count:

• Delivery required by what time
• vessel is a:….. (test, group, wellsite, other) separator
• Design Pressure
• Operating pressure
• Gas flow, MMSCF/d
• HC flow, Bbl/d
• Water flow, Bbl/d
• Gas S.G.
• HC S.G.
• Water S.G.
• Compositions available of above phases?
• Orientation: vertical or horizontal
• Service: sweet or sour
• Vessel to be partially flanged or all-flanged?
• Diameter required (ID or OD)
• Shell length seam to seam
• Inlet/Outlet size required
• Design temperature Min/Max
• Corrosion Allowance
• Special material requirements (i.e. normalized, low or high temperature, impact tested)
• NACE Compliance required Y/N?
• Post Weld Heat Treatment
• Special X-Ray requirements on vessel, or per Code
• Impact testing
• Std Mesh pad, or Vane pack required.
• Registration requirements (i.e. province, country etc.)
• Manway size preference
• Packaging required?
  • Number of phases (2,3, or 4 for sand)
  • Special Weld Testing  required (i.e. % X-Ray on piping, or per code)
  • Insulation
  • liquid outlet(s) size req’d
  • skid required (are there shipping restrictions?)
  • Special color requirements
  • Special paint specifications
  • Internal coating required
  • Inlet header required ( How many wells, what size/ANSI rationg for the lines)
  • Building required?
    • shed or gable style
    • containment lip
    • floor drain, piped to skid edge
    • lift lugs
    • Pull bars
    • No. of doors
    • No. of windows
    • Heater req’d?
      • catalytic (AC or DC start)
      • Ruffnek or similar (Voltage)
• Instrumentation related:
  • Pressure Controller
  • Shutdowns
    • High Level
    • Low Level
    • High/Lo Pressure
    • Emergency Shut Down
    • Gas meter required, and what size
      • Recorder, 2 pen or 3 pen
    • Liquid metering required, which phases?
      • Y-Strainer
      • Bypass
      • Proving taps
      • Totalizers
    • Sampling required
    • SCADA system option? System preference?
  • Fuel Gas scrubber or Instrument air from off-skid
  • Level Controllers, Fisher, Norriseal, Kimray,  Mallard, other
  • Liquid Control Valves, Fisher, Norriseal, Kimray, other
  • Level Gauge, brand preference
  • Valve(s), specification, make/model required
  • Chemical injection,
    • Tank, size, how many
    • Pump: Texteam, or other, how many
      • containment lip for pump
    • Level/rate gauge req’d.
  • Is a P.Eng. design review and approval required (i.e. P.Eng. stamp on drawings, if so which ones, P&ID, General Arrangement, Skid, BOM, Linelist, other?)
  • Other